Assembly Build Process

Sun's Assembly Build Process allows you to configure a cartridge and manifold, or main stage and pilot stage cartridge, and build a digital assembly in three dimensional space. The resulting output of this process is the assembly product page, including configuration-specific images, symbols, product information and CAD files for download.

The Assembly Build Process can be accessed from either a cartridge or manifold product page. Only valid choices are allowed.

From a manifold page, you must first choose your cartridge function. Once you choose your function, click on the BUILD ASSEMBLY button below the WHERE TO BUY BUTTON. Once clicked, you will be presented with valid cartridges for your manifold. Select the cartridge of your choice and follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

From a cartridge product page, click on BUILD ASSEMBLY and you will be presented with a listing of compatible manifolds. In the case of main stage and pilot stage cartridges, you can either build a cartridge to cartridge assembly or a cartridge to manifold assembly. Once your choice has been made, follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

Please note that the Assembly Build Process is an automated process. It can be utilized at any time. Pages are generated typically within minutes but delays can occasionally be expected. In the event of a delay, a team at Sun will work to resolve the issue to ensure you receive your information as quickly as possible.

778系列, 12 VDC 线圈带Deutsch DT04-2P接头带TVS二极管, 通用孔型

全部展开

技术特性 [ + ]

Power cable with mating connector is required and is not included with the coil.
The coil is magnetically symmetrical and can be mounted on the solenoid tube in either direction for best cable access without affecting performance.
This coil includes a transient voltage suppression (TVS) diode.
Coil windings utilize Class F, (311° F [155 °C] rated) magnet wire.
IP rating for this coil is IP67.

回到首页

比例性能数据 [ + ]

20º C下电阻	3.9 ohms ±7%3.9 ohms ±7%
最大电流(最高环境温度且100%工作时间下)	1660 mA1660 mA

回到首页

技术数据 [ + ]

电弧消除(TVS)	IncludedIncluded
最高环境温度	104 °F40 °C
Power Consumption at 68°F (20°C) cold - at rated voltage	36.9 watts36.9 watts
在104°F (40°C)环境温度下，最大线圈温度	284 °F140 °C
电压/频率	12 VDC12 VDC
寿命测试等级	100 %100 %
接头	Deutsch DT04-2PDeutsch DT04-2P
衔铁直径	.75 in.19 mm
线圈锁紧螺母扭矩	3.5 - 3.9 lbf ft4,8 - 5,3 Nm
型号重量	.62 lb.62 lb