Frequently Asked Questions
Can FLeX proportional valves be driven with an explosion proof coil?
Can I adjust a counterbalance valve in the field?
Can I back flow through a reducing valve from port 1 to port 2?
Can I control the motion of a load with a pilot-to-open check valve?
Can I synchronize 2 cylinders with Sun's divider-combiner?
Can I use a flow fuse to prevent the loss of oil?
Can I use a flow fuse to provide fire protection?
Can I use a kick-down relief for my system relief?
Can I use a three-port vented pilot-to-open check valve instead of the four-port version to save on plumbing?
Can I use an atmospherically vented counterbalance valve instead of the four-port version to save on plumbing?
Can I use pilot-to-open check valves with paired cylinders?
Can the +5V reference on the XMD-02 be used in parallel to power two input devices?
Can the XMD Series drivers be used to control non-FLeX coils or non-Sun coils?
Direct acting, pilot operated, what do I use?
Do FLeX valves utilize a floating nose design?
Does the +5V reference need to be used when using a resistive input option on the XMD Driver?
Does the XMD Driver have an internal TVS Diode? Is a coil with or without diode recommended for use with the XMD?
Does this FLeX series throttle control flow bidirectionally?
Every time I try to lower my load the flow fuse trips. What's wrong?
How accurate are Sun's flow controls?