Assembly Build Process

Sun's Assembly Build Process allows you to configure a cartridge and manifold, or main stage and pilot stage cartridge, and build a digital assembly in three dimensional space. The resulting output of this process is the assembly product page, including configuration-specific images, symbols, product information and CAD files for download.

The Assembly Build Process can be accessed from either a cartridge or manifold product page. Only valid choices are allowed.

From a manifold page, you must first choose your cartridge function. Once you choose your function, click on the BUILD ASSEMBLY button below the WHERE TO BUY BUTTON. Once clicked, you will be presented with valid cartridges for your manifold. Select the cartridge of your choice and follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

From a cartridge product page, click on BUILD ASSEMBLY and you will be presented with a listing of compatible manifolds. In the case of main stage and pilot stage cartridges, you can either build a cartridge to cartridge assembly or a cartridge to manifold assembly. Once your choice has been made, follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

Please note that the Assembly Build Process is an automated process. It can be utilized at any time. Pages are generated typically within minutes but delays can occasionally be expected. In the event of a delay, a team at Sun will work to resolve the issue to ensure you receive your information as quickly as possible.

Maximum setting limiter control kit, W control

Expand All

Technical Features [ + ]

Sun offers special control kits for limiting the maximum setting of cartridges with an L adjust within their specified range. These control kits come in two varieties; the basic Maximum Setting Limiter and the Maximum Setting Limiter with Handknob. Once the kit has been successfully installed, the setting of the cartridges can be adjusted within their specified range not to exceed the new permanent maximum setting.

For use on all Sun Cartridges with an L adjustment control except for Series 0, counterbalance, and load control cartridges.
The installation of this kit is permanent. Once installed, it cannot be readjusted or disassembled.
This kit is available factory-set as the W control option on selected cartridge models. See Option Selection on individual cartridge product pages for availability.

Technical Data [ + ]

For Cartridge Models	All Models with an L adjustment control (Except Series 0 and counterbalance)All Models with an L adjustment control (Except Series 0 and counterbalance)
Material	Zinc Plated SteelZinc Plated Steel
Locknut Hex Size	9/16 in.15 mm

Notes [ + ]

Note: To prevent damage to nose end, install this kit while cartridge is screwed into its cavity.
Adjust valve to desired maximum setting and torque locknut to 108 lbf in. (12 Nm).
Remove the existing stop ring from the adjust screw.
Thread the hex cap onto the adjust screw until it bottoms out against the locknut and and tighten to 108 lbf in. (12 Nm).
Insert each pin into one of the hex cap holes and tap with hammer until flush.

Additional Resources [ + ]

Highlights

Sun’s Maximum Setting Limiter

Technical Information

Sun's Floating Style Screw-In Cartridge (1.06 MB)

991022 | Accessories » Cartridge Control Options | Sun Hydraulics

Assembly Build Process

Assembly Build Process

Maximum setting limiter control kit, W control

Footer