Assembly Build Process

Sun's Assembly Build Process allows you to configure a cartridge and manifold, or main stage and pilot stage cartridge, and build a digital assembly in three dimensional space. The resulting output of this process is the assembly product page, including configuration-specific images, symbols, product information and CAD files for download.

The Assembly Build Process can be accessed from either a cartridge or manifold product page. Only valid choices are allowed.

From a manifold page, you must first choose your cartridge function. Once you choose your function, click on the BUILD ASSEMBLY button below the WHERE TO BUY BUTTON. Once clicked, you will be presented with valid cartridges for your manifold. Select the cartridge of your choice and follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

From a cartridge product page, click on BUILD ASSEMBLY and you will be presented with a listing of compatible manifolds. In the case of main stage and pilot stage cartridges, you can either build a cartridge to cartridge assembly or a cartridge to manifold assembly. Once your choice has been made, follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

Please note that the Assembly Build Process is an automated process. It can be utilized at any time. Pages are generated typically within minutes but delays can occasionally be expected. In the event of a delay, a team at Sun will work to resolve the issue to ensure you receive your information as quickly as possible.

Pochette de joints Buna-N pour bloc modulaire Cetop 07

Développer

Caractéristiques techniques [ + ]

Les corps modulaires Sun Cetop 07 sont disponibles pour de nombreuses fonctions de commande dans deux versions. La version dépend de la méthode utilisée pour réaliser l’étanchéité des orifices du plan d’interface. Pour la plupart des blocs modulaires Cetop 07 on utilise une plaque porte joints pour assurer l’étanchéité. Les autres blocs Cetop 07 comportent des lamages sur le plan d’interface destinés à recevoir des joints toriques. Des kits comportant la plaque porte joints seule, les joints, ou les deux combinés sont disponibles.

Toutes les plaques porte-joints Sun sont fabriquées conformément aux standards industriels actuels, respectant la position des orifices et des vis de fixation.
Les corps modulaires Cetop 07 n’ont qu’un seul sens de montage. Ils ne peuvent pas être retournés par rapport à la plaque porte-joints.

Retour Vers le Haut

Caractéristiques [ + ]

Matière des Joints	Buna NBuna N
Epaisseur du Placage	0,08 in.2,03 mm

Retour Vers le Haut

Ressources Complémentaires [ + ]

Informations et Conseils Techniques Pour les Differentes Fonctions Hydrauliques SUN

Blocs Modulaires (575.9 Ko)

Technical Information

Retour Vers le Haut

990140007 | Accessoires » Manifold Seals and Seal Retainer Plates | Sun Hydraulics

Assembly Build Process

Assembly Build Process

Pochette de joints Buna-N pour bloc modulaire Cetop 07

Footer