Assembly Build Process

Sun's Assembly Build Process allows you to configure a cartridge and manifold, or main stage and pilot stage cartridge, and build a digital assembly in three dimensional space. The resulting output of this process is the assembly product page, including configuration-specific images, symbols, product information and CAD files for download.

The Assembly Build Process can be accessed from either a cartridge or manifold product page. Only valid choices are allowed.

From a manifold page, you must first choose your cartridge function. Once you choose your function, click on the BUILD ASSEMBLY button below the WHERE TO BUY BUTTON. Once clicked, you will be presented with valid cartridges for your manifold. Select the cartridge of your choice and follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

From a cartridge product page, click on BUILD ASSEMBLY and you will be presented with a listing of compatible manifolds. In the case of main stage and pilot stage cartridges, you can either build a cartridge to cartridge assembly or a cartridge to manifold assembly. Once your choice has been made, follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

Please note that the Assembly Build Process is an automated process. It can be utilized at any time. Pages are generated typically within minutes but delays can occasionally be expected. In the event of a delay, a team at Sun will work to resolve the issue to ensure you receive your information as quickly as possible.

778 Series, 24 VCC bobine avec ISO/DIN 43650, Forme A Connecteur without TVS Diode, common cavity

Développer

Caractéristiques techniques [ + ]

Les enroulements de bobines utilisent un fil conducteur de Classe H (180°C [356°F]).
Le câble d'alimentation avec contre-connecteur n'est pas livré avec le produit.
The coil is magnetically symmetrical and can be mounted on the solenoid tube in either direction for best cable access without affecting performance.
IP rating for this coil is IP65.
This coil does not include a transient voltage suppression (TVS) diode and should only be used when surge suppression is included elsewhere in the electrical system.

Retour Vers le Haut

Caractéristiques [ + ]

Arc Suppression (TVS)	AucunAucun
Température Ambiante Maximum	104 °F40 °C
Power Consumption at 68°F (20°C) cold - at rated voltage	39.7 watts39.7 watts
Maximum Coil Temperature at 104°F (40°C) Ambient	284 °F140 °C
Tension / Fréquence	24 VCC24 VCC
Plage de Tension de Fonctionnement	Nominal +/– 10%Nominal +/– 10%
Facteur de service	100 %100 %
Connecteur	ISO4400 - EN/DIN175301-803, Form A (ISO/DIN 43650) 3-pinISO4400 - EN/DIN175301-803, Form A (ISO/DIN 43650) 3-pin
Diamètre du Doigt de Gant	0,75 in.19 mm
Couple de Serrage de l'Ecrou de la Bobine	3.5 - 3.9 lbf ft4,8 - 5,3 Nm
Poids du composant	0,62 lb0,62 lb