Assembly Build Process

Sun's Assembly Build Process allows you to configure a cartridge and manifold, or main stage and pilot stage cartridge, and build a digital assembly in three dimensional space. The resulting output of this process is the assembly product page, including configuration-specific images, symbols, product information and CAD files for download.

The Assembly Build Process can be accessed from either a cartridge or manifold product page. Only valid choices are allowed.

From a manifold page, you must first choose your cartridge function. Once you choose your function, click on the BUILD ASSEMBLY button below the WHERE TO BUY BUTTON. Once clicked, you will be presented with valid cartridges for your manifold. Select the cartridge of your choice and follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

From a cartridge product page, click on BUILD ASSEMBLY and you will be presented with a listing of compatible manifolds. In the case of main stage and pilot stage cartridges, you can either build a cartridge to cartridge assembly or a cartridge to manifold assembly. Once your choice has been made, follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

Please note that the Assembly Build Process is an automated process. It can be utilized at any time. Pages are generated typically within minutes but delays can occasionally be expected. In the event of a delay, a team at Sun will work to resolve the issue to ensure you receive your information as quickly as possible.

12 VCC bobine avec ISO/DIN 43650, Forme A Connecteur without TVS Diode - 13mm, common cavity

Développer

Caractéristiques techniques [ + ]

Les enroulements de bobines utilisent un fil conducteur de Classe H (180°C [356°F]).
Le câble d'alimentation avec contre-connecteur n'est pas livré avec le produit.
IP rating for this coil is IP65.
This coil does not include a transient voltage suppression (TVS) diode and should only be used when surge suppression is included elsewhere in the electrical system.
La bobine est magnétiquement symétrique et peut être montée dans les deux sens sur le doigt de gant du solénoïde sans influencer les performances.

Retour Vers le Haut

Caractéristiques [ + ]

Plage de Température de fonctionnement	-4 to 215 °F-4 to 215 °F
Arc Suppression (TVS)	AucunAucun
Puissance consommée (à froid) - à une tension donnée	20.5 Watts20.5 Watts
Température Ambiante Maximum	104 °F40 °C
Tension / Fréquence	12 VCC12 VCC
Plage de Tension de Fonctionnement	Nominal +/– 10%Nominal +/– 10%
Facteur de service	100 %100 %
Connecteur	ISO4400 - EN/DIN175301-803, Form A (ISO/DIN 43650) 3-pinISO4400 - EN/DIN175301-803, Form A (ISO/DIN 43650) 3-pin
Diamètre du Doigt de Gant	.51 in..51 in.
Couple de Serrage de l'Ecrou de la Bobine	44 lbf in.44 lbf in.
Poids du composant	0,35 lb0,15 kg