Assembly Build Process

Sun's Assembly Build Process allows you to configure a cartridge and manifold, or main stage and pilot stage cartridge, and build a digital assembly in three dimensional space. The resulting output of this process is the assembly product page, including configuration-specific images, symbols, product information and CAD files for download.

The Assembly Build Process can be accessed from either a cartridge or manifold product page. Only valid choices are allowed.

From a manifold page, you must first choose your cartridge function. Once you choose your function, click on the BUILD ASSEMBLY button below the WHERE TO BUY BUTTON. Once clicked, you will be presented with valid cartridges for your manifold. Select the cartridge of your choice and follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

From a cartridge product page, click on BUILD ASSEMBLY and you will be presented with a listing of compatible manifolds. In the case of main stage and pilot stage cartridges, you can either build a cartridge to cartridge assembly or a cartridge to manifold assembly. Once your choice has been made, follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

Please note that the Assembly Build Process is an automated process. It can be utilized at any time. Pages are generated typically within minutes but delays can occasionally be expected. In the event of a delay, a team at Sun will work to resolve the issue to ensure you receive your information as quickly as possible.

Bobine 12 VCC bifilaire

Développer

Caractéristiques techniques [ + ]

Les enroulements de bobines utilisent un fil conducteur de Classe N (200°C [392°F]).
Matière du surmoulage : matériau composite moulé à base de fibre de verre renforcée, et résine époxy.
Une varistance à oxydes de zinc SIOV-S07K35 est surmoulée à l’intérieur de la bobine pour protéger les circuits électriques contre les effets de self.
La bobine est magnétiquement symétrique et peut être montée dans les deux sens sur le doigt de gant du solénoïde sans influencer les performances.
L'indice IP dépend du connecteur monté sur la bobine et aussi du connecteur qui vient s'y brancher
Conforme à la directive européenne RoHS. Le poids des matériaux restreints est inférieur à 0,1% du poids total.

Retour Vers le Haut

Caractéristiques [ + ]

Température maximum de la bobine à 20°C (68°F) Ambiant	105° C105° C
Arc Suppression (TVS)	IncludedIncluded
Puissance consommée (à froid) - à une tension donnée	12 watts12 watts
Tension / Fréquence	12 VCC12 VCC
Plage de Tension de Fonctionnement	Nominal +/– 20%Nominal +/– 20%
Facteur de service	100 %100 %
Connecteur	Bifilaire 16 AVG x 610 mm (24")Bifilaire 16 AVG x 610 mm (24")
Indice de protection du connecteur	IP65IP65
Diamètre du Doigt de Gant	0,56 in.14,2 mm
Couple de Serrage de l'Ecrou de la Bobine	4,5 lbf in.0,5 Nm