Assembly Build Process

Sun's Assembly Build Process allows you to configure a cartridge and manifold, or main stage and pilot stage cartridge, and build a digital assembly in three dimensional space. The resulting output of this process is the assembly product page, including configuration-specific images, symbols, product information and CAD files for download.

The Assembly Build Process can be accessed from either a cartridge or manifold product page. Only valid choices are allowed.

From a manifold page, you must first choose your cartridge function. Once you choose your function, click on the BUILD ASSEMBLY button below the WHERE TO BUY BUTTON. Once clicked, you will be presented with valid cartridges for your manifold. Select the cartridge of your choice and follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

From a cartridge product page, click on BUILD ASSEMBLY and you will be presented with a listing of compatible manifolds. In the case of main stage and pilot stage cartridges, you can either build a cartridge to cartridge assembly or a cartridge to manifold assembly. Once your choice has been made, follow the instructions at the top of the page. If your particular combination has been generated before, the resulting assembly page will be available immediately. If not, you will be asked to enter your email address. Once the page is complete, an email will be sent to you including a link to the assembly product page.

Please note that the Assembly Build Process is an automated process. It can be utilized at any time. Pages are generated typically within minutes but delays can occasionally be expected. In the event of a delay, a team at Sun will work to resolve the issue to ensure you receive your information as quickly as possible.

XMD Series CAN-to-USB hardware interface

Expand All

Technical Features [ + ]

The XMD CAN-to-USB hardware interface cable is a USB 2.0 high-speed device that allows the Controller Area Network (CAN) in the XMD to be transmitted and received using the CANpoint XMD Configuration Software on a computer or laptop.

This interface cable is required when using the CANpoint XMD Configuration Software to configure an XMD valve driver,
Circuit board is protected by a conformal coating for resistance to extreme environmental conditions.
CAN activity LED flashes green when it successfully receives CAN messages and flashes red after any CAN bus errors. The USB LED offers the same functionality for USB communication activity.
The interface is powered by the USB bus from the computer.
Includes a Deutsch 3-way receptacle and a 120-ohm terminating resistor. A second 120-ohm resistor will be needed in the network.
USB cable is approximately 16 feet (4.9 m) long, and the CAN connection is approximately 1 foot (0,3 m).

Technical Data [ + ]

Power Requirement	USB bus (<125 mA @ 5V)USB bus (<125 mA @ 5V)
Cable Length	16 ft16 ft

Used With [ + ]

What models can this kit be used with?

XMD-01 Configurable single-output driver used con proporcional y solenoid-operated switching valves
XMD-02 Configurable double-output driver used con proporcional y solenoid-operated switching valves

Additional Resources [ + ]

Realces

Electrohidráulica optimizada y ajustada de fábrica desde el primer momento

Technical Information

Sun's Floating Style Screw-In Cartridge (1.06 MB)
CE Declaration of Conformity - XMD 12-2017 (133.69 KB)
XMD Mobile App User Guide (10.31 MB)
XMD Coil Clip Installation Guide (749.23 KB)
Electro-Hydraulic Solutions (3 MB)
CANpoint Quick Start Guide (3.6 MB)

991728 | Electrónica » I/O Modules » Accesorios | Sun Hydraulics

Assembly Build Process

Assembly Build Process

XMD Series CAN-to-USB hardware interface

Footer